Learning How To Tile A Bathroom Floor

Tiling a bathroom floor is a fairly easy DIY project, as long as you know how to proceed. This includes understanding how to prep the subfloor and ensure that everything is level, lest you end up with tiles that sit unevenly. This will lead to cracks in the long run. Here are some useful tips to help you get that travertine tile floor installed, courtesy of floor tile dallas tx.

Prep Your Subfloor

It all starts by ensuring that the floor is level. You’ll need to take a six-foot-long level and run it over the entire floor, checking it from all angles. This means that by the time you’re done, you’ll be able to identify any dips in the floor that could cause problems. Once you’ve found them, you need to fix these areas. This is the first step involved in prepping the subfloor.

However, if your subfloor is damaged, you will need to remove the stained, waterlogged, or broken boards and then replace them. It is never good to lay your new tile floor over a damaged subfloor. It will just cause more problems in the long run.

pexels-photo-534179

Set the Membrane

Before you can lay your tiles down, you will need to lay a membrane down on the subfloor. This ensures that the entire floor is waterproof and that it will remain that way. You won’t have to worry about any moisture seeping through the tiles into the subfloor. The membrane must be adhered into place with thin-set and then allowed to dry fully before you move on to the next step.

Laying the Tiles Out On the Floor

The next step is the one where you’ll see forward progress being made. Depending on the room, you’ll either need to start in the center or at the edge of the bathtub. No matter what, you’ll end up working your way outwards as you begin to lay out the tiles. Remember to take the time to set them all in place without adhesive and grout so that you can see how the floor will look once it’s finished. Note any that need to be cut, and then take care of that before you start adhering the tiles to the floor.

Set the Tiles in Place

Now, you can go ahead and secure those tiles. Follow the instructions on the adhesive and apply it in thin, light coats. You’ll need to work with one small patch of floor at a time in order to ensure that you don’t end up with dried adhesive that will make the floor too thick in places. Once again, you’ll want to work from the center of the floor outwards.

Spread Out Your Grout

After all of the tiles are glued down, it’s time to grout them. This ensures that they’ll stay in place and it will add the finishing touch that the floor needs.


Author Description

No Responses to “Learning How To Tile A Bathroom Floor”

Leave a Reply

Your email address will not be published. Required fields are marked *

*